mezcladora alesis multimix 4 usb eliminador

Not sure how that compares to what you are using. I use LOOPBACK for audio routing in the Mac. I don't monitor from the Phone out on the mixer. The thing that I do differently is I monitor all my stream audio from my MAC. But I wanted to check here first to see if anyone could diagnose my issue for me. So basically, I guess my question is - does having a physical mixer (Alesis Multimix 4) allow me the range of OBS controls that I'm looking for? Or is it simply a medium between my headphones and my OBS audio? I know this is more of a setup question and I intend to have an A/V buddy of mine stop by and grade my setup. Yeah, I can't hear myself in my cans and it doesn't register (much) on the OBS volume slider, but it's not truly muted, as my desktop audio doesn't return to its original volume until the mic track is muted on OBS. Turning down my mic on the mixer doesn't make much of an effect. I have it configured via the audio filters but the audio will only truly return to its original volume if I mute the microphone slider via OBS. I'd like to know if there was a way my physical mixer could control the OBS audio levels, especially considering I'm using multiple channels. It doesn't change anything on-screen or in OBS. Is it possible to control OBS volume sliders with my physical mixer?Īll lowering my audio on the mixer does is decrease the volume in my headphones. I downloaded the iShowU digital audio capture device so that I could pull sound from my iTunes without the outside noise of my mic. (think of this, except with an on-air personality: ) You could instead select the other 'USB Audio Codec' for Playback Engine, but then you would only get input - no output (fine if you just need to capture something without monitoring then switch back to the other to play back).I have an alesis multimix 4 4-channel mixer and I'm using OBS to run a Youtube live stream that is simply my iTunes music and me narrating/hosting on my microphone. (Still might need to Default your I/O in the Input and Output tabs.) So try launching Pro Tools with N and select Pro Tools Aggregate I/O for your Playback Engine. Pro Tools Aggregate I/O gets around this limitation by allowing you to combine the Input and Output of your CoreAudio device to treat it as one. If you are selecting 'USB Audio Codec' then that is either just the Input or just Output of your Alesis (sounds like the latter based on your problem). Pro Tools can only have 1 'device' as its Playback Engine.

I have attached another screen shot to show what I see. I do have USB CODEC selected as the Playback engine.

I initially DID have to start with the N key down because I was getting the prompt that the I/O was not recognized (or something like that).

Mezcladora alesis multimix 4 usb eliminador